Introduction - Montigo BF52-ST Installation, Operation & Maintenance Manual

f i r e f e a t u r e
About the BF-Series-ST Power Vented Fireplaces:
The BF-Series-ST See-thru Gas fireplace is available in three sizes,
and is rated for Natural Gas and Propane;
BF52-ST Natural Gas and Propane, at 150,000 BTU/H (43.50

Kilowatts) Input.
BFL52-ST Linear Burner, Natural Gas and Propane, at 150,000

BTU/H (43.50 Kilowatts) Input.
BF60-ST Natural Gas and Propane, at 200,000 BTU/H (58.00

Kilowatts) Input.
BF84-ST Natural Gas and Propane, at 280,000 BTU/H (81.20

Kilowatts) Input.
Warranty and Installation Information:
The Montigo warranty will be voided by, and Montigo disclaims any
responsibility for, the following actions:
 Modification of the fireplace and/or components including the vent
assembly or glass doors.
Use of any component part not manufactured or approved by

Montigo in combination with this Montigo fireplace system.
Installation other than as instructed in this manual.

Consult your local Gas Inspection Branch on installation requirements
for factory-built gas fireplaces. Installation & repairs should be done
by a qualified contractor.
CAUTION!
Due to its high operating temperatures, the appliance
should be located out of traffic & away from furniture and
draperies.
Children and adults should be alerted to the hazards

of the high surface temperature, which could cause
burns or clothing ignition.
 Young children should be carefully supervised when
they are in the same room as the appliance.
Clothing or other flammable materials should not be

placed on or near the appliance.
Part No. XG0711 - 022410

Introduction

Installations in Canada must conform to the current CAN/CGA
B-149.1 and .2 Gas Installation Code and local regulations. This ap-
pliance must be electrically grounded in accordance with CSA C22.1
Canadian Electrical Code Part 1 and/or Local Codes.
Installations in the USA must conform to local codes, or in the
absense of local codes to the National Fuel Gas Code, ANSI Z223.1-
1988. The appliance must be grounded in accordance with local
codes or, in the absence of local codes, with the National Electrical
Code, ANSI/NFPA 70-1987.
Within the State of Massachusetts this fireplace must comply with
NFPA-54 Chapter 10.
Warranty and Installation Information:
The Montigo warranty will be voided by, and Montigo disclaims any
responsibility for, the following actions:
Modification of the fireplace and/or components including vent

assembly or glass doors.
Use of any component part not manufactured or approved by

Montigo in combination with this Montigo fireplace system.
Installation other than as instructed in this manual.

Consult your local Gas Inspection Branch on installation requirements
for factory-built gas fireplaces. Installation & repairs should be done by
a qualified contractor.
When this appliance is installed directly on carpeting, tile or any
combustible material other than wood flooring, it must be installed
on a metal or wood panel extending the full width and depth of
the appliance.
BF-Series-ST Gas Fireplace
WARNING!
Page 3