Rear Panel - Fender Jazzmaster Owner's Manual

INPUT POWER
500W
�����
��
����� FUSE ���
���� ����
��������� ���������
���� �������
L. POWER— Switches the unit ON-OFF.
M. IEC POWER INPUT SOCKET— Connect to a grounded
outlet in accordance with the correct Voltage Selector
setting for your location. When you travel outside your
country, make sure you have a power cord compatible
with each destination.
N. FUSE— Protects the amplifier from electrical faults. Only
replace a blown fuse with the type and rating specified
for the correct Voltage Selector {O} setting. Install the cor-
rect fuse when you change the Voltage Selector setting
and before connecting the power cord. To replace the
fuse, first remove the power cord, then use a screwdriver
to pry the fuse holder out from the input socket.
O. VOLTAGE SELECTOR— Set according to the local power
supply before connecting the power cord.
P. SPEAKER OUTPUT— Connect one of the following speak-
er configurations:
• A Jazzmaster™ Ultralight Enclosure—connect using the
supplied Speakon® cable.
• A 2-ohm guitar speaker cabinet (capable of handling
250-watts )—connect using a 2-conductor cable with a
Speakon® plug on one end and a plug matching the
speaker input on the other end.
• A 4- or 8-ohm speaker will work, but the power output
from the amplifier will be reduced by the mismatch.
Never connect a speaker load of less than 2-ohms to
avoid overloading the unit.
CAUTION:
20 volts present
tors and the amplifier will shut down if either
one comes into contact with a grounded surface.
Any exposed metal on plug jackets must
not touch ground when speaker cables are
connected; use insulated (plastic) plug jackets whenever
possible.

Rear Panel

�������
Speaker outputs have
on BOTH conduc-
◊
���� ��������
������ �����
������
����
����
���
��� ���
Q. LINE OUTPUT— Speaker emulated, balanced XLR output
for connection to sound equipment.
• Ground Lift press IN to disconnect the ground connec-
tion (pin 1) from the Line Output jack which may reduce
noise from non-standard local wiring.
whenever noise is not a problem.
• Line Out Level adjusts signal strength to accommodate
input sensitivities of external equipment.
XLR Pin Out (Wiring)
1 Ground
2 Positive
3 Negative
R. FOOTSWITCH— Plug in the included footswitch to enable
remote channel selection and effects on-off switching for
each channel as indicated by the footswitch LEDs. The
front panel Channel Select button is disabled when the
footswitch is plugged in. Connect the footswitch using an
unshielded speaker cable rather than an instrument cable
whenever possible.
S. TUNER OUT— Connect your tuner here. Press Tuner/
Mute {I} on the front panel for silent tuning.
Recommended Enclosure: The Fender®
Jazzmaster™ Ultralight Enclosure
(Part Number: 227-7700-000)
◊
���������� ���������
Leave OUT
7