JUKI LBH-1790 Instruction Manual page 46

(2) Method of editing cycle data
1) Set the mode to input mode.
When the back-light of LCD display q shows the
input mode in blue color, it is possible to input the
cycle data. When the back-light is the sewing mode
in green color, press READY key w
over to the input mode.
2) Call cycle data No. to edit.
Press PATTERN No. key u
selection screen, and pattern No. B which is
selected at present flashes on and off. Press ITEM
SELECTION key !0
have been registered are changed over and
displayed in order. Cycle data No. and continuous
stitching data No. which have been registered after
the last registered pattern No. are displayed. Here,
select the cycle data No. which you desire to sew.
3) Set cycle data to editing status.
Press DATA key i
display C appears. Pattern No. D which is sewn
first flashes on and off. In this state, it is possible to
edit the data.
4) Select editing point.
Press ITEM SELECTION key !0
editing point moves in order and flashes on and
off. When moving the editing point up to the last
data, additional indication pictograph
displayed.
5) Change data of selected editing point.
Press DATA CHANGE key !1
editing point can be changed.
Pattern No. which has been registered is displayed
and it is possible to select.
In addition, press RESET key e
pattern data of editing point can be deleted.
Repeat steps 4) and 5) to perform editing data.
to change
to call pattern
, and patterns which
, and cycle data editing
, and
is
and data of
, and the
e
w
C
u
i
41
q
D
!0
!1