JUKI LBH-1790 Instruction Manual page 35

No.
Compensation of bar-tacking width, right
S10
This item adjusts right side outer shape of bar-tacking
section in terms of overedging section.
Top of Bottom of
square square type
type
Compensation of bar-tacking width, left
S11
This item adjusts left side outer shape of bar-tacking
section in terms of overedging section.
Top of Bottom of
square square type
type
Taper bar-tacking offset, left
S12
This item sets length to form bar-tacking section of
taper bar-tacking shape.
Taper bar-tacking offset, right
S13
This item sets length to form bar-tacking section of
taper bar-tacking shape.
Eyelet shape length
S14
This item sets upper side length from center of eyelet
of eyelet shape.
Number of stitches of eyelet shape
S15
This item sets number of stitches in the upper 90˚ of
eyelet shape.
Eyelet width
S16
This item sets crossuise size of the inside of eyelet
shape. Actual needle entry point is the dimension to
which S04 Knife groove width, left is added.
Eyelet length
S17
This item sets lengthwise size of the inside of eyelet
shape.
Round type shape length
S18
This item sets upper length from the center of round
type shape.
Top of
Top of
round Radial
type type
Bottom Bottom
of round of radial
type type
Number of stitches of radial shape
S19
This item sets number of stitches in the upper 90˚ of
radial shape.
Reinforcement of radial shape
S20
This item sets with/without reinforcement stitching of radial shape.
: With
Pitch at bar-tacking section
S21
This item sets sewing pitch of bar-tacking section.
Top of Top of
square round
type type
Bottom of
Bottom
of square round
type type
Item
Bottom of
straight bar-
tacking
Bottom of
straight bar-
tacking
Top of
semilunar
type
Bottom of
semilunar
type
: Without
Top of
semilunar
Bottom of Bottom of
type
straight taper bar-
bar-tacking tacking
Bottom of
semilunar
type
30
Setting range Edit unit
-1.00 to 1.00 0.05mm
-1.00 to 1.00 0.05mm
0.00 to 3.00 0.05mm
0.00 to 3.00 0.05mm
1.0 to 10.0 0.1mm
1 to 8 1
1.0 to 10.0 0.1mm
1.0 to 10.0 0.1mm
1.0 to 5.0 0.1mm
1 to 8 1
– –
0.200 to 2.500 0.025mm
Remarks
–
–
*1
*1
*1
*1
*1
*1
*1
*1
*1, *2
–