BMW 5251 Service Manual page 91

110-19
Engine Removal and Installation
M62 engine, remove ASC throttle body.
Disconnect electrical harness from throttle position sensor.
-
Disconnect ASC actuator cable (arrow).
.
Remove mounting fasteners and remove throttle body.
On front of left side cylinder head, disconnect electrical har-
ness connector (A), and remove and plug fuel tank vent valve
vacuum line ( 0 ) .
Raise car and support in a safe manner.
CAUTION-
Male sure the car is stable and well supported at aN times.
Use a professional automotive lifi orjackstands designed for
I
the ouroose. A floor jack is not adequate support.
Working beneath car:
-
Remove engine splash shield.
Remove right and left heat shield from front suspension
subframe.
Working underneath engine compartment, disconnect
ground cable on right side engine mount (arrow).