BMW 5251 Service Manual page 615

4
Remove nuts (arrows) from constant velocity joint mounting
bolts at final drive. Pry constant velocity joint free from final
drive input flange at groove (A).
-
Hang driveshaft rear section from body using stiff wire.
<
Do not let driveshaft hang unsupported, as rear CV joint rub-
ber boot (arrow) may be damaged.
4
Remove center support bearing mounting nuts (arrows)
-
Remove driveshaft. Pull down on center of driveshaft to
facilitate removal.
CAUTIOI\C
Protect CVjoint with plastic cover.