Outer Door Lock Cylinder, Removing And Installing - BMW 5251 Service Manual

51 5-1 8
I
Central Locking and
Anti-Theft
<
Working at outer door edge:
Disconnect inside door release Bowden cable guide by
sliding mounting clip (A) forward.
Remove latch mounting fasteners (B) and (C) and remove
latch.
NOTE-
In the photo below, door handle assembly and latch assem-
bly are shown removed from the car for clarity.
Installation: Slide latch into position in door making sure that
cross-shaped tip of door loclc cylinder mechanism fits cor-
rectly into corresponding opening in latch mechanism (in-
set).
Remainder of installation is reverse of removal. Operate loclc
using key before installing door trim panel.
Tightening torques
Airbag
to
door (replace screws) 8.5 Nm (75
in-lb)
Outer door lock cylinder, removing and
installing
-
Close window on subject door. Open all other windows
-
Disconnect battery negative (-) cable.
CA U T I O I G
Prior to disconnecting the baffeg read the battery discon-
nection cautions given in 001 General Warnings a n d Cau-
tions.
-
Remove door trim panel. See 411 Doors.
-
Remove door air bag. See 721 Airbag System (SRS).
-
Remove outer door handle. See Door handle (outer), re-
moving and installing.
-
Remove door latch. See Door latch, removing and install-
ing.