Dimension One Spas Spa Owner's Manual page 10

Ozone bubbles will continue to rise from the skimmer compartment UltraPure™
bleeder valve as long as the valve remains open. Once the jets are working, be sure
that the bleeders are closed tightly.
14. After you have the jets functioning properly, replace and
close the bleeder valves and push the UP/DOWN Buttons
until your desired water temperature (called the "Set
Temperature") appears in the Display Window. The Display
Window will show your Set Temperature for thirty seconds
before reverting to show the current water temperature.
The Display Window will not allow you to set the temperature above 104° F (≅40°C).
However, if the water temperature exceeds 104° F (≅40° C), the display will show the
actual temperature. Never get in water if the temperature exceeds 104° F (≅40° C).
15. Once the spa has begun heating, you can reinstall the equipment compartment panel
removed in Step 2.
You can confirm that the heater is on by checking that the Heat Indicator light at the
right side of the control panel is glowing.
Depending upon the size of the hot tub and the size of the circuit breaker used, your
spa will heat at approximately 3° F (≅1.65° C) to10° F (≅5.5° C) per hour.
16. After completing the above steps, see the Water Care Guide (provided separately) to
ensure proper water chemistry.
17. Place the thermal cover on the hot tub to conserve energy and to keep it ready for use.
Dimension One Spas – Reflections Owner's Manual
8