Cleaning The Filter Screens - Dimension One Spas Spa Owner's Manual

Cleaning the Filter Screens

The Filter Screen is a black plastic perforated cylinder located at the bottom of the canister that
holds the filter. It normally requires no maintenance. However, if your spa is frequently telling you to
clean the filter, or if the spa is reporting "low water flow," you may want to clean the screen in
addition to the filter.
Remove the filter screen by inserting the tip of a flat-blade
screwdriver into the slot as shown, and gently apply outward
pressure until the catch releases. Then lift the black screen to
remove it from the filter canister. Outside the spa, rinse the screen
with water using pressure from inside the screen.
Cleaning the UltraPure Inner Filter Screen
The UltraPure filter (if you spa is equipped with it) contains a metal
Inner Filter Screen inside the black plastic Filter Screen. (This inner
screen is not present in the skimmer filter).
To clean the Inner Filter Screen, first remove the entire plastic Filter Screen as described above.
Then press the Filter Screen (with the Inner Filter Screen inside) back onto the base of the spa filter
canister.
Finally, replace the filter into its canister and replace the lid.
Then turn the power back on, (or exit the "Standby" Mode, if you used it, as described above).
Dimension One Spas – Reflections Owner's Manual
First, remove the filter(s) as described in the Filter Cleaning section
above.
Then locate the black plastic Filter Screen at the base of the filter
canister (see photo at left).
To prevent debris from getting into the pump, be sure to
remove any floating debris BEFORE removing the Filter
Screen.
Then remove the Inner Filter Screen
and clean both screens with water,
using pressure from the inside of
each screen.
Replace the Inner Filter Screen into
the plastic Filter Screen by lining up
the grooves (shown by the arrow in
the photo) and pressing it snugly
into position.
30