Dimension One Spas Spa Owner's Manual page 17

Erroneous
Temperature on the
Display
Ice
Cooling
Summer Mode
15
Dimension One Spas – Reflections Owner's Manual
DO NOT ENTER THE WATER if you see a temperature reading of 32° F
(≅0° C) or 136° F(≅57.8° C) without first checking the actual water
temperature with a certified thermometer. The system has detected a
Temperature Probe Failure and the water may be too hot, or too cold,
to safely use.
Contact your local Authorized Dimension One Spas Dealer, or
authorized service center.
When ICE CONDITION appears in the Display Window, the air
temperature has dropped below a factory-preset level, and the
system has activated "Smart Winter Mode." The pump will
automatically run to circulate the water and prevent it from
freezing.
This is a normal hot tub function. No corrective action
is necessary.
When "COOLING" appears beside the water temperature in the
Display Window, the water temperature has reached 2° F (≅1° C)
above the set temperature. The circulation pump and ozone
generator will turn off to allow the water to cool back to the set
temperature. This is a normal hot tub function. No corrective action
is necessary.
The circulation pump and ozone generator will run
while either jet pump is on. They will remain on for 30
minutes after the pump(s) turn off regardless of the
water temperature.
The "SUMMER MODE" feature (available only in the Scrolling
Message Center models) allows the circulation pump to continue
running even when the spa exceeds the Set Temperature. During
hot weather, normal filtering can cause the spa to exceed the Set
Temperature, which halts circulation pump so the spa can "cool
off." If your spa is not filtering enough during hot weather, you can
put it in Summer Mode to allow the pump to keep running.
To initiate SUMMER MODE, use the Down Button to set the
temperature below 59° F (15°C). SUMMER MODE will appear in the
Display Window. In this mode the pump will run the filter cycle until
the water reaches 107°F (41° C) before turning off. It will remain off
until the water temperature falls to 102° F (38° C) at which point the
pump turns on again.