Term
Control Panel
Unions
Venturi
Troubleshooting Guide
Heating System
Symptom
Problem
1.
Does not heat
2.
3.
Too hot
1.
2.
Possible temperature sensor
Flashing
temperature of
failure
34°F or 134°F
appears on the
display
Water level
Hot Tub
Temperature
erratic
Electrical System
Symptom
Problem
Will not turn on
No power
– in any mode
Turns on by
Normal automatic daily power
filtration, or anti-freeze cycle
itself
Light is out
Burned out bulb
1.
Pump shuts
down
unexpectedly
2.
while in use
3 flashing LEDs
Possible sensor errors
appear on the
Top Side
Control
20
2002 @ Home Hot Tubs
Owner's Manual
Definition
cycles, and other advanced functions.
Connects the spa plumbing to the equipment. The unions allow a service technician to
remove equipment without cutting plumbing.
A device used to inject air into the water.
Corrective Action
Temperature setting is too
1.
low
Dirty filter
2.
Pressure switch
3.
malfunction
Temperature setting is to
1.
high
High limit tripped
2.
Call for service
Fill hot tub to 6 inches (15.24 cm) below lip of spa
Corrective Action
Check circuit breaker and/or GFCI
No action required
Replace bulb
Automatic timer has shut
1.
pump off
Motor over-heated and
2.
automatic protective
device has shut down
pump(s)
1.
2.
If problem persists:
1.
2.
If problem persists:
Turn up the thermostat
Clean filter
Call for service
Turn down the thermostat
Call for service
Push JETS pad again to start another cycle
If pump(s) will not restart when JETS pad is pushed, call for service
Make sure that the equipment panel vent area is not blocked. Vent blockage can
cause serious damage to your equipment.
Check water level
Clean filter
Turn off power
Restart the system
Call for service