Maintenance; Draining Your Hot Tub; Cleaning Your Filter; Light Bulb Replacement - Dimension One Spas Home Hot Tubs Planning And Installation Manual

Maintenance

Draining Your Hot Tub

Locate the hose bib at the bottom of the hot tub, on the pedestal, to the left of the equipment compartment
on Dimension One hot tubs, and to the right on @Home hot tubs. This is where you can hook-up your hose
for hot tub draining.

Cleaning Your Filter

Your hot tub is equipped with one or two top access filter cartridges. For optimum performance and water
quality, we recommend that you clean the filters every month. Before you fill your hot tub, practice removing
and reinstalling a filter cartridge.
The EZ Lock Filter does not require excessive force to remove or install. "Finger-tip"
pressure is all that is needed.
Note

Light Bulb Replacement

Notice the location of the light. To change the bulb, drain hot tub below the level of the light and unscrew the
light cover using the special tool provided in the owner's manual packet.
Never try to remove the light housing cover without the special tool.
Note

Caring For Your Hot Tub Cover

The thermal cover for your hot tub is an extremely durable foam insulated product. See the manufacturer's
literature for proper cleaning instructions. When the hot tub is not in use, it is recommended that the cover
locks always be utilized to discourage unsupervised use and to minimize heat loss

Hot Tub Specifications

The following section of this manual gives you detailed information on the sizes of both Dimension One and
@Home hot tubs. Dimension One hot tubs are listed first, alphabetically by model, followed by @Home hot
tubs in the same order.

Specifications for Dimension One Spas

These specifications include:
•
spa shape,
•
dimensions,
•
electrical requirements,
•
water capacity,
•
type and number of Hydrotherapy Jets,
•
weight,
•
type of Water Management System,
•
number and type of pumps,
•
type of skirt,
•
type and number of controls
6
.