Monarch 9855 Quick Reference page 16

613 Reference point off supply.
614 Portion of field off supply or there may be an invalid character in
the packet.
703 The printer sensed a calibration of different-sized black marks.
Make sure the correct supply type is loaded.
704 Printer has not sensed a supply mark when expected or is out of
supplies. Press Escape/Clear and try to continue printing.
Change supply.
Printer did not sense a black mark when expected.
751
Press Escape/Clear and try to continue printing. Change supply.
Printer sensed a mark in the wrong place.
752
Printer sensed a mark that is too long.
753
Check for a ribbon jam or remove any slack in the ribbon by turning
754
the take-up reel clockwise. Load a new ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.
757 Load supplies (supply length mismatch). Press Feed/Cut.
758 Either the supply is not seen, the on-demand sensor is broken, or a
label was removed too quickly. Check for a label jam or reload
supplies.
763 Waiting to dispense label. Press Feed/Cut.
765 The printhead has less than 8 bad dots and can shift bar code
fields to avoid bad dots. Press Escape/Clear to continue printing.
Printhead has more than 8 bad dots within the format area or is not
768
connected. Connect printhead.
14