Monarch 9855 Quick Reference page 12

Press the left arrow or the right arrow to select either "Yes" or "No" to
4.
print a test label and check the print contrast. Press Enter/Pause.
Press Escape/Clear until you see the Main menu.
5.
C l e a r i n g J a m s
When you are printing and a jam occurs, the Fault light on the printer's
front panel blinks.
1. Turn off the printer and open the cover and printhead assembly.
If necessary, remove the label roll and ribbon.
2.
Remove the jammed labels and reload the label roll.
3.
Close the printhead assembly and turn on the printer.
4.
Press Feed/Cut several times to feed at least three labels/tags to
5.
properly position the supply and the ribbon.
C l e a n i n g
You must clean the printhead as described below to maintain printhead
life.
Caution: Do not use sharp objects to clean the printhead
or touch the printhead. This may damage the
printhead and require a service charge.
The rate and frequency at which you print determines how
often you must clean the printer. You may need to clean the
printhead, sensor, and platen roller:
♦
if there is any adhesive build-up in the supply path.
♦
after printing approximately 3 rolls of thermal
transfer/thermal direct/linerless supplies or after each ribbon.
♦
daily if your printer is in an excessively dirty, hot, or humid
environment.
♦
if you frequently receive supply error codes or when you see voids or
streaking in the print as shown.
1. Turn off the printer and open the cover and printhead assembly.
2. Remove the label roll and ribbon (when cleaning the printhead).
Press down on the exit cover tabs to open the exit cover on the front
3.
of the printer.
10
Voids
Streaks