Test Program (1C): Choosing Tests - Bosch WFMC3200UC Training Manual

58
WFMC Service Tips
WFMC Service Tips
Understanding WFMC3200 & WFMC6400 test programs:
1. Generating fault codes: Most fault codes are generated by running specific tests.
2. Viewing fault codes: Fault codes are viewed only by running test P1 (WFMC6400) / P:01 (WFMC3200),
not during each test.
3. Procedure: 1 - select test based on expected problems (see below). 2
st
test P1 (P:01) to see faults. Scroll through each fault and check if it occurred.
HINT: To run tests, push Start/Pause button. To end tests, push:
• Menu button (WFMC6400)
• Spin Selection button (WFMC3200)
To check door
Fault codes
latch:
generated during wash
– run test P1 (P:01)
To check drain
Run test
pump:
P15, P9 (P:09)
To check water inlet
(pressure switch, flow
Run test
meter):
P8
(WFMC64 only), P9 (P:09),
P11 (WFMC64 only), P13
--

Test Program (1C): Choosing Tests

-- Test Program (1C): Choosing Tests
To check motor:
Run test P4 (P:04)
To check
fault codes:
Run test P:1
(P01)
To check wire
Run
harnesses:
test P4 (P:04), P8
(WFMC64 only)
HINT: To scroll through tests, push:
• Menu button (WFMC6400)
• Spin Selection button (WFMC3200)
nd - run test. 3 rd - go back and run
To check motor
Run test
control:
P4 (P:04)
To check heater:
Run test P16
To check NTC:
Run test P16
1st Edition/Revision 6 (2/2/04)