36
Disassembly
Disassembly
To remove drum drive motors:
• Remove rear panel
• Remove rear tub spring
• Remove drum belt
• Disconnect wire harnesses
• Remove two motor bolts, then pull motor out
toward rear of washer
WARNING: The drum drive motor & tub are grounded
through the motor control. Since the tub is plastic and
the motor is isolated from the frame, Its critical the
ground leads from the tub, drive motor & motor control
are connected properly.
Rear tub
spring
–
–
Drum Drive Motor
Drum Drive Motor
10mm bolts
Drum drive
motor
1st Edition/Revision 6 (2/2/04)