Test Program - Bosch WFMC3200UC Training Manual

53
WFMC/WFXD Service Tips
WFMC/WFXD Service Tips
(1A): Starting WFMC32/WFXD52 Test Program
(1A): Starting WFMC32/WFXD52 Test Program
The WFMC32/WFXD52 washer test programs self-diagnose problems, including listing the last 8
fault codes from the control module & the last 16 fault codes from the motor control. The tests are
easy to use, speeding up and simplifying diagnosing washer issues.
WFMC32
Entering & using WFMC32/WFXD52 test programs:
•
To reset, rotate cycle selector knob to Off position.
• To enter test program, push and hold Spin Selection and Delay Start buttons at the same time,
then rotate cycle selector knob ccw to Permanent Press Cold position. Hold Spin Selection
and Delay Start buttons until P:01 shows in display.
• To select tests, push Spin Selection button (to scroll through tests) until desired test shows in
display (P:01 - P:17) - Start/Pause light will flash.
• To start tests, push Start/Pause button while its light is flashing -- light stays lit when test has
started. To end tests, push Spin Selection button.
•
To exit test program, rotate cycle selector knob to Off position.
R020031E
P:01
/
–

Test Program

– Test Program
NOTE: Door locks
for all water fill and
drain tests.
HINT:
Start/Pause
doesn't come on for
some tests, door is
open. Turn
washer, then close
door.
2nd Edition/Revision 0 (4/28/04)
If
light
off