Test Program (1A): Starting Wfmc3200 Test Program - Bosch WFMC3200UC Training Manual

56
WFMC Service Tips
WFMC Service Tips
The WFMC3200 washer test programs self-diagnose problems, including listing the last 8 fault
codes from the control module & the last 16 fault codes from the motor control. The tests are easy
to use, speeding up and simplifying diagnosing washer issues.
WFMC3200UC
Entering & using WFMC3200 test programs:
•
To reset, rotate cycle selector knob to Off position.
• To enter test program, push and hold Spin Selection and Delay Start buttons at the same time,
then rotate cycle selector knob ccw to Permanent Press Cold position. Hold Spin Selection
and Delay Start buttons until P:01 shows in display.
• To select tests, push Spin Selection button (to scroll through tests) until desired test shows in
display (P:01 - P:17) - Start/Pause light will flash.
• To start tests, push Start/Pause button while its light is flashing -- light stays lit when test has
started. To end tests, push Spin Selection button.
•
To exit test program, rotate cycle selector knob to Off position.
WFMC3200 Test Program
WFMC3200 Test Program
P:01
-- Test Program (1A): Starting
-- Test Program (1A): Starting
NOTE: Door locks
for all water fill and
drain tests.
If
HINT:
light
Start/Pause
doesn't come on for
some tests, door is
open. Turn off
washer, then close
door.
1st Edition/Revision 6 (2/2/04)