Test Program (1B): Starting Wfmc6400 Test Program - Bosch WFMC3200UC Training Manual

57
WFMC Service Tips
WFMC Service Tips
The WFMC6400 washer test programs self-diagnose problems, including listing the last 8 fault
codes from the control module & the last 16 fault codes from the motor control. The tests are easy
to use, speeding up and simplifying diagnosing washer issues.
WFMC6400UC
Entering & using WFMC6400 test programs:
•
To reset, rotate cycle selector knob to Off position.
• To enter test program, push and hold Menu and Select buttons at the same time, then rotate cycle
selector knob ccw to Permanent Press Cold position. Hold Menu and Select buttons until P1:
Errors shows in display.
• To select tests, push Menu button (to scroll through tests) until desired test shows in display (P1 -
P17) - Start/Pause light will flash.
• To start tests, push Start/Pause button while its light is flashing -- light stays lit when test has
started. To end tests, push Menu button.
•
To exit test program, rotate cycle selector knob to Off position.
WFMC6400 Test Program
WFMC6400 Test Program
P1:ERRORS
-- Test Program (1B): Starting
-- Test Program (1B): Starting
NOTE: Door locks
for all water fill and
drain tests.
If
HINT:
light
Start/Pause
doesn't come on for
some tests, door is
open. Turn off
washer, then close
door.
1st Edition/Revision 6 (2/2/04)