Table of Contents
Advertisement
RESIDENTIAL FREESTANDING INSTALLATION
Select an installation location that will give best airflow from front of
PREPARING STOVE FOR INSTALLATION
1. Inspect unit for any obvious physical damage.
2. Plug power cord into a 115V AC outlet. Do not run power cord under unit or in high traffic areas.
3. Check primary air draft control to ensure that it slides freely.(See Figure 5).
4. Remove any items from within firebox. Spread a dropcloth one floor behind heater. Next, tilt
heater so that back is on drop cloth.
5. ( Leg Kit ): If legs are to be used, obtain four legs, attach legs to holes in bottom of unit with bolts
and washers supplied with leg kit. (See Figure 5).
6. ( Pedestal Kit ): If pedestal kit is being used and (out side air is required for residential free
standing installation (see page 29 Out Side Air Installation). Open freestanding kit and obtain
stand. Place stand against bottom of heater (angle side to heater).Center stand front to rear and
also center stand left and right. Mark screw locations on bottom of stove through outer holes of stand
mounting angles. Set stand aside and drill four 7/32" holes in heater bottom. Then mount stand to
bottom of heater with screws provided. (See Figure 5A).
7. Obtain four (4) 3/16" self-tapping screws and secure stand to heater.
8. Reposition heater to upright position.
PRIMARY AIR
DRAFT CONTROL
SECTION IV
heater to remainder of home.
HOLES FOR MOUNTING PEDESTAL
Figure 5A
Figure 5
Page 16
PEDESTAL
Advertisement
Table of Contents
