Toshiba DK14 Installation And Maintenance Manual page 296

DK424i Installation
Step 5: Install Reserve Power
Bolt Cabinets to Wooden Floor
1. Mount the DK424i Base Cabinet on Floor
Mount Fixtures (BFIF). See
and 7-18.
2. Position the Base Cabinet at the selected
installation location.
3. Mark the floor where holes will be drilled.
Move the Base Cabinet prior to drilling.
Note
4. Drill pilot holes to make insertion of 3/8
inch lag bolts easier, and to prevent
splitting of wood flooring.
5. Move the Base Cabinet into position on the
equipment room floor.
6. Secure the Base Cabinet to the floor using lag bolts, lock washers, and flat washers
Bolt Cabinets to Computer Room Floor
1. Mount the DK424i Base Cabinet on Floor Mount Fixtures (BIMF). See
2. Position the Base Cabinet at the selected installation location.
3. Mark the floor where holes will be drilled. Move the Base Cabinet prior to drilling.
Note
4. Drill holes through tile for 3/8-inch threaded rods.
5. After the tiles have been drilled, insert threaded rods through the holes in the tile and mark the
concrete floor directly beneath the holes in the tiles.
6. Remove the tiles. Use a hammer drill to make holes for 3/8-inch bolt anchors.
7. Install the bolt anchors with plugs in the
drilled holes.
8. Using the driving tool and a hammer, drive
each bolt anchor into the floor.
9. Screw threaded rods into each bolt anchor.
10. Install a hex nut, lock washer, and flat
washer on each threaded rod. Screw the
nuts down far enough to allow floor tiles
to be replaced over the threaded rods.
11. Replace tiles over threaded rods in their
original positions on the floor.
12. Reach under the tiles, and screw the hex
nuts upward until the flat washers are
touching the bottom of the tile.
7-34
Cover the Base Cabinet with a drop
cloth to protect the power equipment
from dust created during drilling.
Cover the Base Cabinet with a drop cloth to protect the power equipment from dust
created during drilling.
Figures 7-17
Base
Cabinet
BFIF
(Floor
mount
fixture)
Figure 7-20 Installation on Wooden Floor
Bottom
Cabinet
Flat Washer
Lock Washer
Hex Nut
Figure 7-21 Installation on Computer Room Floor
Wooden
Floor
Figures 7-17
BFIF
(Floor
mount
fixture)
Floor Tiles
Lead Anchors
Concrete
Strata DK I&M
Bolt
Lockwasher
1468
and 7-18.
1469
5/00