Cabinet Floor Mounting; One Or Two Cabinets; Three Or More Cabinets - Toshiba DK14 Installation And Maintenance Manual

Cabinet Floor Mounting

One or Two Cabinets

1. Remove front, side, and top covers from cabinet(s)
from all cabinet back covers using a Phillips screwdriver
2. Make sure that cabinet power supplies (RPSU280) are installed per
Installation" on Page
3. If installing just one cabinet, install the RFMF fixtures on each side of the bottom of the
cabinet (Figure
4. If installing two cabinets, install a floor fixture (RFMF1) on each side of the cabinet that will
be the bottom cabinet, making sure that the fixture is inside of the cabinet edge.
5. If installing two cabinets:
Set the bottom cabinet on the floor or mount surface, then set the top cabinet on the bottom
o
cabinet.
o Fasten the two cabinets together with the four screws provided: (two screws at front "A"
and two at back "B" of cabinet. Place cabinet where it should be installed.
o Connect the Expansion Cabinet data cable to the "CAB. 2" data cable connector on the
Base Cabinet
...or if installing a Remote Expansion Cabinet: see details in
6. Install ground wiring, AC and reserve power cabling, and PCB cabling per the
"Recommended Installation Sequence" on Page
7. Fill out cabinet/slot identification labels on cabinet(s)
8. Reinstall covers on to cabinet(s).

Three or More Cabinets

This section shows you how to mount three or more cabinets to a concrete, wood or computer
room floor. Use the General Steps for all of these methods first, then the specific steps that follow
for each method.
1. Make sure that cabinet power supplies (RPSU280) are installed per
Installation" on Page
2. Remove front, side, and top covers from all cabinets
Remove plastic locating parts from all cabinet back covers using Phillips screwdriver
5-5).
3. Install a floor fixture (RFMF1) on each side of the bottom cabinet. (Make sure that the fixture
is inside of the cabinet edge. For Steps 3~10, see
4. Place cabinet two on top of the bottom cabinet and connect them together at points A and B
with the screws provided.
5. Place cabinet three on top of cabinet 2 and connect them together at points A and B with the
screws provided.
6. If installing more than three cabinets, install wall brackets (RWBF1) on the top of cabinet 3.
Position the 3 cabinets parallel to the wall (2 inches from the wall) and secure the wall
brackets to the wall with customer-provided wood screws and wall anchors as required.
Strata DK I&M 5/00
5-8.
5-13) and place the cabinet where it should be installed (go to Step 6).
(Figures 5-10 and 5-28).
5-8.
(Figure 5-2). Remove plastic locating parts
(Figure 5-6).
"Power Supply
Figure 5-41 on Page
5-7.
(Figure 5-11).
"Power Supply
(Figure 5-2).
Figures 5-13~5-18.
DK424 Installation
Cabinet Floor Mounting
5-62.
(Figure
5-21