Inserting And Removing Terminals; Charging Terminals In The Chargebase - Hand Held Products Dolphin 9500 User Manual

Inserting and Removing Terminals

1. To insert the terminal, hold the terminal with the bottom panel perpendicular to the base.
2. Slide the terminal into the well until the Dock LED lights solid green.
3. Charging begins immediately.
Note: To remove a terminal, grasp it firmly in your hand and lift it up and out of the terminal well. The LEDs for the terminal well
turns off.

Charging Terminals in the ChargeBase

The Dolphin ChargeBase charges the main battery of each terminal in less than four hours. The ChargeBase uses the intelligent
battery charging system incorporated into all Dolphin terminals that prevents overcharging. This means that Dolphin terminals
may be stored in the ChargeBase indefinitely without damage to the terminals, battery packs, or the ChargeBase.
1. Power the ChargeBase; see
2. Insert a terminal into a terminal well; see
3. The Charge LED lights green to indicate that the terminal is powered and charging.
14 - 4
D O L
P H I
N 9
5 0 0
PO WE
R
S C A N
S FT E S C
TA B +
N U M
E N T
1
A 2
B 3
SE ND
C
4 D
5
E
6
F EN D
G
7 H
8
I
9
J
K
- L
M 0
,
N
O
;
: P
F1
Q
F2 *
R
F 3
@ S
F4
F5 T
U F 6
V F7
ST A RT W F8
X
IN S
Y
BK SP
Z
DE L
S P
CT RL
AL T
Supplying Power to the ChargeBase
Inserting and Removing Terminals
on page 14-3.
on page 14-4.
Dolphin® 9500 Series Mobile Computer User's Guide