Step 4. Initialize the Mobile Computer
1. Power on the terminal by pressing the POWER or SCAN key. The decode LED lights and the scan LED blinks for
approximately three seconds. Do NOT press any keys while the terminal is booting up.
2. The terminal initializes and the HHP splash screen displays for a few seconds. The Build numbers indicate the software
version number.
3. The system performs a hard reset. When the display activates again, follow the instructions that appear.
Step 5. Align the Screen
You are prompted to align the screen by tapping the target five times. Use the stylus provided by HHP.
• Alignment should always be performed with a stylus designed for touch screen applications. The small point is required for
accurate calibration.
• Press the stylus firmly into the center of the cross-hair target once and release. Do not "double-tap" the target.
• You can re-align the screen at any time by going to
2 - 8
7.XX
7.XX
Bootloader
Kernel
>
Start
Settings
7.XX
Keyboard
>
tab >
.
System
Screen
Dolphin® 9500 Series Mobile Computer User's Guide