Installation Procedure - Toshiba RAS-10SKVR-E2 Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
6
5
Filter
Batteries
3
Wireless remote control
2
Before installing the wireless remote controller
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (− ) positions.

10. INSTALLATION PROCEDURE

Filter
8
Pan head
Remote control holder
4
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
2 Wireless remote controller
Hook
1 Installation
plate
Shield pipe
Saddle
Extension
drain hose
(Not available,
provided by installer)
3 Batteries
– –
47
FILE NO. SVM-10029
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom Rear
right left
Bottom left
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
Left