Installation Procedure - Toshiba RAS-25G3KVSG-ND Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
Flat head
wood screw
6
Battery
cover
!
9
Flat head
wood screw
Batteries
3
6
Flat head
wood screw
2
Wireless remote control
The provided Remote Controller is a wireless
type, which also can be used as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)

10. INSTALLATION PROCEDURE

Refrigerant piping
must be protected from
physical damage.
Install a plastic cover or
equivalent.
4
Remote control
holder
Before installing the wireless remote controller
following the (+) and (-) positions.
Hook
1
Installation
plate
Shield pipe
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available, provided
by installer)
2 Wireless remote controller
- 61 -
For the rear left, bottom left and left piping
Wall
Cut out a piece of SPACER from indoor
unit packaging box, roll it and insert
between the indoor unit and wall to tilt
the indoor unit for better operation.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom Rear
right left
Bottom left
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries
Left