Table of Contents
Advertisement
2
INSTALLATION PROCEDURE
Installation diagram of indoor unit
For rear left and side pipe exit
Insert the cushion between the
indoor unit and wall, and lift indoor
unit to make work easier.
Do not allow the drain hose to sag.
Cut the piping
hole sloped
slightly
Make sure to run the drain hose
sloped downward.
Mounting the installation plate
For installation of the indoor unit,
use the paper template included.
When the installation plate is directly mounted on the wall
1. Securely fix the installation plate to the wall by screwing it through the upper and lower fixing holes.
2. To mount the installation plate on a concrete wall with anchor bolts, utilize the anchor bolt holes as illustrated in
the above figure.
3. Attach the installation plate horizontally to the wall.
When installing the installation plate with mounting screw, do not use the anchor bolt hole.
Otherwise the unit may fall down and result in personal injury and property damage.
∅5 mm hole
Clip anchor
(local parts)
3
Toshiba 1074007701(01EN)_P01-10
Wall
Hook
Mounting screw
∅4 x 25 mm
5
1
Hook
Installation
plate
Pipe
insulation
Mounting screw
Hook
1 7 0
0
1 2 0
10 0m m
Hook
Pipe hole
Thread
Weight
Indoor unit
CAUTION
4
7/16/04, 13:30
TOSHIBA RAV-SM561KRT-E (EN) 1074007701
Insulate the refrigerant pipes
separately with insulation, not
together.
Min. 6 mm thick heat resisting
polyethylene foam
The auxiliary piping can be
connected the left, rear left, rear,
right or bottom.
Right
Rear
Bottom
Rear left
Left
55
65
Installation
18 0
80 10 0
plate
10 0m m
Indoor unit
Hook
Pipe hole
Mounting screw
Anchor bolt
Projection
15 mm or less
EN
Advertisement
Table of Contents
