TRENDnet TW100-S4W1CA User Manual page 16

2-1-7 Reset
In the event that the Broadband Router stops responding correctly or in
some way stops functioning, perform the reset function. The settings will
not be changed. To perform the reset, click the "Reset" button. The reset
will be complete when the system light starts blinking.
2-2 WAN
The Broadband Router can be connected to the service provider in any of
the following ways: Dynamic IP Address, Static IP Address, PPPoE, and
PPTP.
2-2-1 Dynamic IP
The Host Name is optional, but may be required by some Service
Providers. The default MAC address is set to the WAN's physical
interface on the Broadband Router. If the Service Provider requires the
host name, click the "Clone MAC Address" button to copy the MAC
address of the Network Interface Card installed in the selected PC. The
WAN MAC address will be replaced by this MAC address.
The road runner management is optional. If the ISP needs to run the road
runner management (sometimes called Big Pond), enable it.
27
2-2-2 Static IP
If the Service Provider has
assigned a fixed IP address,
enter the assigned IP
address subnet mask and
gateway address provided.
Click "yes" if using two or
more IP addresses.
2-2-3 Dial-up xDSL (PPPoE)
If you're connecting to the Internet using a Dial-up xDSL (PPPoE)
Modem and your ISP has provided you with a Password and Username,
then your ISP uses PPPoE. Select this option, and enter the required
information. If the ISP provided a Service Name, enter it in the Service
Name field. Otherwise, leave it blank.
The Service Name, IP Address, and DNS Address fields must be
completed if your ISP provided you with this information. If your ISP
Provider provides a Dynamic IP Address, you should skip these fields.
The MTU feature specifies the
largest packet size permitted for
network transmission. Enter the
value desired; for most DSL
users, 1492 is recommended. By
default, MTU is set at 1492.
The Maximum Idle Time feature
can control the connection time
if you want to reduce connection
28