TRENDnet TW100-S4W1CA User Manual page 12

1-2 WAN Connection Type
To select the WAN connection-type, select Cable modem (DHCP), Fixed
IP, or Dial-up xDSL (PPPoE)
1-2-1 Cable modem (DHCP)
To connect to a Cable (DHCP) Internet connection with the Broadband
Router, check the cable modem with the related user's guide. The Cable
modem will automatically configure itself, and the Broadband Router is
configured to automatically assign addresses to each PC.
Input the MAC Address of the network adapter if the DNS server needs a
particular address, or press the "Clone MAC Address" button to get the
manager's PC MAC Address.
19
1-2-2 Fixed IP
If your Internet Service Provider (ISP) has assigned you a fixed IP address,
select this option. Enter the assigned IP address, subnet mask, gateway IP,
and DNS IP addresses for your Broadband Router.
1-2-3 PPPoE (Dial-up xDSL)
If your DSL Internet connection is PPPoE (Dial-up xDSL), your ISP will
have provided you with a Password and Username. Select this option, and
enter the required information. If your ISP provided a Service Name,
enter it in the Service Name field. Otherwise, leave it blank.
The Service Name, IP Address, and DNS Address fields must be
completed if your ISP provided you with this information. If your ISP
Provider provides a Dynamic IP Address, you should skip these fields.
The MTU feature specifies the
largest packet size permitted for
network transmission. Enter the
value desired; for most DSL
users, 1492 is recommended. By
default, MTU is set at 1492.
The Maximum Idle Time feature
can control the connection time
if you want to reduce connection
fees charged by your ISP
(default time=0, always connect).
Check the Connect-on-demand box to enable your router to connect your
ISP whenever an Internet connection is required.
20