Electrical System; Removing The Battery; Installing The Battery - Husqvarna TE 125 EU Owner's Manual

15

ELECTRICAL SYSTEM

15.1

Removing the battery

Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least 15
minutes and contact a physician.
15.2

Installing the battery

x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Pull back the negative terminal cover
battery.
–
Pull back the positive terminal cover
battery.
–
Detach rubber band
–
Lift the battery up and out.
B01788-10
x
Main work
–
Insert the battery with the terminals facing forward into the battery compartment.
Battery (YTX5L-BS)
–
Attach rubber band
Info
Contact disk
the claws facing down.
–
Position the positive cable and mount and tighten the screw.
Guideline
Screw, battery terminal (TE 250/300)
–
Slide positive terminal cover
–
Position the negative cable and mount and tighten the screw.
Guideline
Screw, battery terminal (TE 250/300)
–
Slide negative terminal cover
B01789-10
Finishing work
–
Mount the seat. (
p. 51)
and disconnect the negative cable from the
1
and disconnect the positive cable from the
2
at the bottom.
3
.
1
must be mounted between screw
A
M5
over the positive terminal.
2
M5
over the negative terminal.
3
p. 51)
80
and cable lug with
4 5
2.5 Nm (1.84 lbf ft)
2.5 Nm (1.84 lbf ft)