12
SERVICE WORK ON THE CHASSIS
12.47
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
x
(TE 125)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
L01702-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Hydraulic oil (15) (
–
On the slave cylinder, remove bleeder screw
L01705-10
–
Inject the liquid into the system until it escapes from hole
der without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
L01703-10
(TE 250/300)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01538-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder, remove bleeder screw
L01645-10
.
1
with membrane
.
2
3
with the appropriate hydraulic fluid.
4
p. 119)
4 mm (0.16 in)
.
1
with membrane
.
2
3
with the appropriate hydraulic fluid.
4
p. 119)
and mount bleeding syringe
5
of the master cylin-
6
and mount bleeding syringe
5
64
.
4
.
4