Installing The Shock Absorber; Removing The Seat; Mounting The Seat - Husqvarna TE 125 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.19

Installing the shock absorber

12.20

Removing the seat

12.21

Mounting the seat

–
Remove screw
–
Lift off the shock absorber.
L01664-11
x
Main work
–
Slip in the shock absorber from the top.
–
Position the shock absorber.
–
Mount and tighten screw
Guideline
Screw, top shock absorber
L01664-10
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
L01669-11
Finishing work
–
Install the main silencer. (
–
Install the right side cover. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Lift up the seat at the rear, pull it back, and then lift it off.
B01819-10
–
Attach the front of the seat to the collar bushing of the fuel tank and lower the seat at
the rear while pushing forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screws for securing the seat.
Guideline
Remaining screws, chassis
L01630-01
.
5
.
1
M10
.
2
.
3
M10
p. 54)
p. 55)
in the recessed grips on the left and right.
1
Loctite
60 Nm
(44.3 lbf ft)
M14x1.5 80 Nm (59 lbf ft)
60 Nm Loctite
(44.3 lbf ft)
p. 43)
M6 10 Nm (7.4 lbf ft)
51
® 2701™
® 2701™