Husqvarna TE 125 EU Owner's Manual page 62

12 SERVICE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding guard:
–
Change the chain sliding guard.
–
Check the chain sliding guard for tightness.
» If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
Guideline
Screw, chain sliding
guard
L01639-10
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding piece:
–
Change the chain sliding piece.
–
Check the chain sliding piece for tightness.
» If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
L01640-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
–
Check the chain guide for tightness.
» If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
B01634-01
Finishing work
–
Remove the motorcycle from the lift stand. (
x
M6 6 Nm
(4.4 lbf ft)
x
M8
x
M6
M6
p. 43)
60
Loctite ® 243™
15 Nm
(11.1 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)