Mount the Device
Before you Install the C360 in a Rack
When installing C360 in a rack, ensure that the equipment is positioned such that it will not
●
cause the rack to become unstable or tip over.
Ensure that the combination of equipment in the rack will not cause an overload or
●
overcurrent condition on the power strip being used and/or the customer's branch circuit.
The C360 units weigh a maximum of 15 pounds (6.8 kg). Be careful when installing or
●
removing the C360 product from the rack.
If a power strip is being used in the rack, ensure that it has a reliable earth connection. If
●
the C360 equipment will be plugged directly into a wall outlet, ensure that there is a
reliable ground connection at the outlet.
Ensure that the internal rack ambient temperature is within the operating specification
●
limits of the C360.
Ventilation for the C360 is from side to side. Ensure that there is adequate space on each
●
side of the C360 equipment when installed in the rack to allow sufficient airflow.
Place the C360 in the rack as follows:
1. Position the brackets on the C360 as shown in
Figure 3: C360 Rack Mounting
Figure notes:
1. Front mount position
18 Quick Start for Hardware Installation: The Avaya C360 Converged Stackable Switch
Figure
2. Mid-mount position
3.
2
1