Cleaning The Spray Assembly - KitchenAid KAR-13 Technical Education

8. Pull out on the left and right locking tabs,
and pull the reservoir out of the unit. Empty
the reservoir, and then reinstall it.
9. Dilute approximately 5 oz. (148 ml) of
LIME-A-WAY ®
(3.8 lit.) of water.
10. Slowly pour the cleaning solution into the
reservoir.
Pull Out
11. Position the master switch to the WASH
position.
12. After circulating the cleaning solution for
30 minutes, position the master switch to
OFF.
13. Remove the reservoir and drain it, then
reinstall it in the unit.
14. Turn on the water to the ice maker.
15. Position the master switch to the WASH
position and allow the water to circulate for
5 minutes.
16. Position the master switch to OFF and
immediately back to WASH and allow the
system to rinse.
17. Repeat steps 15 and 16 three times to
completely rinse the system.
cleaner with 1 gallon
Reservoir
Master Switch

CLEANING THE SPRAY ASSEMBLY

NOTE: If the ice maker spray assembly re-
quires further cleaning, perform the following
steps.
1. Lift the ice chute off the front and rear
frame pipes and remove the chute from
the unit.
2. Pull the end of the discharge tube off the
spray assembly nozzle.
Discharge Tube
3. Pull the spray assembly out of the unit.
8-2
Rear Frame Pipe
Front Frame Pipe
Ice Chute
Spray Assembly
Spray Assembly