KitchenAid KAR-13 Technical Education page 19

14. Remove the screw from the right side of
the water recirculation pump cover. Grasp
the drain hose at the bottom of the cover,
then pull down and forward, and remove
the cover from the unit.
Water Recirculation
Pump Cover
15. Remove the six screws from the rear chan-
nel cover and remove the cover from the
ice maker.
Rear
Channel
Cover
Screw
Drain Hose
Screw (1 0f 6)
4-5
16. Disconnect the recirculation pump 3-wire
connector.
17. Cut the indicated wire tie.
18. Remove the green ground wire screw.
Cut Wire Tie
19. Remove the four evaporator screws and
the four ice making housing screws.
Ice Making Housing
Screw (1 of 4)
Continued on the next page.
Ground Screw
3-Wire Connector
Evaporator Screw (1 of 4)