Operation - Delta TP305 Instruction Manual

CUTTERHEAD GUARD
1. Attach the cutterhead guard (A) Fig. 7 to the planer
by inserting the end of the guard over the top of the
cutterhead. Place the slots in the cutterhead guard
(C) over the tapped holes (B).
2. Fasten cutterhead guard (A) Fig. 8 to planer using
two knobs, one of which is shown at (D).
MAKE SURE THAT THE CUTTERHEAD
GUARD IS PROPERLY SECURED
WITH
OPERATING THIS MACHINE.
FASTENING PLANER TO
SUPPORTING SURFACE
During operation, if there is any tendency for the planer
to tip over, slide or "walk" across the supporting surface,
the planer must be secured to the supporting surface.
Four holes (two of which are shown at (A) Fig. 9) are
provided for this purpose.
OPERATIONAL CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING PLANER
1. The on/off switch (A) Fig. 10 is located on the front of the planer motor. To turn the machine "ON,"
move the switch up to the "ON" position.
2. To turn the machine "OFF", move the switch (A) down to the "OFF" position.
MAKE SURE THAT THE SWITCH IS IN THE "OFF" POSITION BEFORE PLUGGING IN THE POWER
CORD. IN THE EVENT OF A POWER FAILURE, MOVE THE SWITCH TO THE "OFF" POSITION. AN
ACCIDENTAL START-UP CAN CAUSE INJURY.
LOCKING SWITCH IN THE "OFF" POSITION
IMPORTANT: When the tool is not in use, the switch should be locked in the "OFF" position to prevent
unauthorized use. To lock the switch, grasp the switch toggle (D) Fig. 11 and pull it out of the switch (A). With the
switch toggle (D) removed, the switch will not operate. However, should the switch toggle be removed while the saw
is running, the machine can be turned "OFF," but cannot be restarted without re-inserting the switch toggle (D).
THE KNOBS BEFORE

OPERATION

B
A
A
9
C
Fig. 7
D
Fig. 8
A
Fig. 9