Fujitsu SPARC Enterprise M4000 Product Notes page 35

XCP Issues Fixed in Releases Earlier Than XCP 1091 (Continued)
TABLE 6
ID Description
RTIF1- If an invalid SMTP server is configured, a
070912-001 subsequent attempt to disable email service
(using the setemailreport CLI) may block
for up to 30 minutes.
RTIF1- While executing the firmware update by using
070914-001 the flashupdate(8) command or BUI, when
the import of XCP executed by using the
getflashimage(8) command or BUI, the
firmware update aborts.
RTIF1- When the XSCF switching performed, the
070914-002 monitor message doesn't show the number of
XSCFU which turned Active.
RTIF1- When the XSCF switching performed, there
070914-003 may be "SCF: Board control error
(DMA timeout)" stored in the error log.
RTIF1- On the XSCF Web, when using Internet
070914-005 Explorer 7, on the User Accounts screen, User
Local Accounts doesn't show the Status of each
user.
RTIF1- When you set the XSCF user account name to
070914-006 the maximum 32 characters, you can log in,
but then, when you execute the XSCF Shell or
operate the XSCF Web, "Permission
denied" occurs.
RTIF1- On the XSCF Web, when you use Internet
070914-007 Explorer and select Log Archives, the Status of
Log Archiving screen doesn't show the status
information.
RTIF1- On the XSCF Web, when you select POP or
070914-008 SMTP-auth on the SMTP screen to enter
Password, the input value doesn't appear as
"*".
RTIF1- On the XSCF Web, when selected POP or
070914-009 SMTP-auth on the SMTP screen, the setting
can be done while the input field remains
blank. And despite the setting done, the past
setting data appears.
Workaround
Wait for the CLI to complete. The rest of the
system will function normally during this
time.
• The CLI can also be aborted by ^C. Note
that the operation (disabling emailreport) is
completed, even if ^C is used.
• showemailreport can be used to confirm
that the service has been disabled.
Do not execute the import of XCP by using the
getflashimage(8) command or BUI, while
executing the firmware update.
Execute the
showhardconf
refer to the state of XSCFU.
No workaround is available.
This message can be safely ignored.
None available at this time.
Use up to 31 characters to set the XSCF user
account name.
None available at this time.
None available at this time.
None available at this time.
Information About Software
(8) command to
25