Faceplate & Trim - FPI E33-NG1 Owners & Installation Manual

INSTALLATION
FACEPLATE & TRIM
1) Lay the faceplate panels fl at, face down on
something soft so they don't scratch.
2) Take the top faceplate and align the holes
in it with the holes in the side panels. Using
the screws provided, attach from the top of
the panel (the holes in the top panel are
slightly larger than the holes in the side
panel to facilitate easier installation). Refer
to Diagram 1.
Hint: Don't tighten the screws down
completely at this point, continue on with
steps 3 and 4 and do a trial fi t to the unit.
Make any necessary adjustments and
when it fi ts properly then tighten down the
screws.
Rear View: Faceplate Assembly
Diagram 1
18
3) Using the connectors provided, join the left
side trim (with the ON/OFF switch) to the
top trim. Diagram 2. Connect the right side
trim to the top trim.
Rear View: Trim Assembly
Diagram 2
4) Place the trim on the assembled faceplate
panels, aligning the wire connections from
the switches with the notch on the left side
panel.
5) Connect the fan switch wires by taking the
black and red wires with the male ends (in
the grey harness) and connect them with
the wire connectors from the fan speed
control.
6) Connect the ON/OFF switch wires by taking
the black and red wires with the female ends
and connect them to the ON/OFF switch.
7) Tuck the wires into the faceplate to keep
them away from the insert using the clip
provided. Attach the clip to the rear of the
faceplate to ensure that the wires do not
touch the side of the unit. Refer to Diagram
3.
8) The power cord should be run behind the
faceplate panel.
Diagram 3
9) Attach the trim to the faceplate by using the
plated screws (refer to Diagram 4).
Diagram 4
10) Attach the faceplate panels to the insert
body using the 4 remaining black screws.
Refer to Diagram 5.
Diagram 5
11) Push the FPI logo plate into the two holes
in the bottom left corner of the faceplate.
E33 FPI Direct Vent Gas Insert