Log Installation; Faceplate & Trim - FPI U35-NG Owners & Installation Manual

INSTALLATION

LOG INSTALLATION

WARNING: Dangerous operating condi-
tions may occur if these logs are not
positioned in their correct certified loca-
tions. Read the following instructions
carefully and refer to the attached dia-
gram.
1) Remove the logs from the box and carefully
unwrap them. The logs are fragile, handle
with care. Do not force into position.
2) Place the rear log on the rear log support in
the back of the unit with the flat side of the
log facing the back of the unit. Carefully
push the log down onto the pins.
3) Sprinkle the vermiculite and ember combi-
nation on the sides of the firebox base.
4) Place the front logs in the unit, aligning the
holes on the underside of the logs with the
log support pins in the front of the unit.
Carefully push the logs down onto the pins.
(Hint: Install the front right side first.)
10
5) Test for pilot ignition.
6) Install the door and louvers.
NOTE: There are NO Rockwool or Large
Ember pieces used on the U35 Log
Set.
FACEPLATE & TRIM
INSTALLATION
1) Lay the faceplate panels flat, face down on
something soft so they don't scratch.
2) Take the top faceplate and align the holes in
it with the holes in the side panels. Using the
screws provided, attach from the top of the
panel (the holes in the top panel are slightly
larger than the holes in the side panel to
facilitate easier installation). Diagram 1.
Hint: Don't tighten the screws down com-
pletely at this point, continue on with
steps 3 and 4 and do a trial fit to the unit. Make
any necessary adjustments and when it fits
properly then tighten down the screws.
3) Using the connectors provided, join the left
side trim (with the ON/OFF switch) to the top
trim. Diagram 2. Connect the right side trim
to the top trim.
4) Place the trim on the assembled faceplate
panels, aligning the wire connections from
the switches with the notch on the left side
panel.
Rear View: Faceplate Assembly
Diagram 1
Rear View: Trim Assembly
Diagram 2
5) Connect the fan switch wires by taking the
black and red wires with the male ends (in
the grey harness) and connect them with
the wire connectors from the fan speed
control.
6) Connect the ON/OFF switch wires by tak-
ing the black and red wires with the female
ends and connect them to the ON/OFF
switch.
7) Tuck the wires into the faceplate to keep
them away from the insert using the clip
provided. Attach the clip to the rear of the
faceplate to ensure that the wires do not
touch the side of the unit.
Diagram 3.
8) The power cord should be run behind the
faceplate panel.
U35 FPI Direct Vent Gas Insert