The Production Server Can Not Attach To The Printer - Rimage 2000i Knowledge Base

Rimage 2000i™ Knowledge Base
6. Select Properties.
7. Change Startup Type from Automatic to Manual.
8. Click OK.
9. Reboot the computer.
Important!
c:\Rimage\Interfaces\pofile.pof and c:\Rimage\Interfaces \iofile.iof. Reboot the
computer.

The Production Server can not attach to the printer.

Important! Try these solut
•
Reseat the USB cable.
1. Power off the 2000i.
2. Disconnect the USB ca
3. Connect the cable, en
4. Power on the 2000i.
•
Run diagnostic test 3.
This test uses one disc to calibrate the distanc
sup ly bin. p
1. Remove all discs from the Rimage 200
2. Ac ess and select diagnostic test 3. c
a. Press and hold the operator button until BUTTON DIAGNOSTICS displ
operator panel.
b. Release the operator button. The Rimage 2000i is in diagnostics mode.
c. Press the operator button three times and hold it on the third press.
3. When 03 CALIBRATE DIAGNOSTIC displays, hold the operator button unt
TEST RELEASE BUTTON displays.
4.
Follow the instructions on the LCD: PLACE ONE DISC INTO SUPPLY BIN.
Note: Please ensure only a single disc is in the supply bin. Running diagnostic test 3
o
with more than one disc will cause the system to operate incorrectly.
August 3, 2007
rd
If your 3 party software requires the bridge server, delete
ions in the order they are presented.
ble.
suring that they are all secure.
0i.
©Rimage 2007
e from the lift arm homing position to the
ays on the
il STARTING
36