Lorex Edge Lh300 Series Dvr: Frequently Asked Questions; Monitor/Display; Q: Why Can't I See An Image When I Connect My Monitor To The Dvr - Lorex Edge LH300 Series Frequently Asked Questions Manual

Lorex Edge LH300 Series DVR: Frequently Asked Questions

Monitor/Display:

Q: Why can't I see an image when I connect my monitor to the DVR?

A: Solution 1: Check the order that you plugged in the monitor
• You must plug in the DVI/VGA cable between the monitor and DVR. Then power on the monitor
before powering on the DVR.
• If the order is reversed, the monitor may not detect the DVR.
Solution 2: Use a different monitor to change the DVR resolution
• Connect a different monitor to the DVR. If you can see an image, change the default resolution
of the DVR (1280 x 1024) to a lower resolution (for example, 800 x 600).
To change the screen resolution:
1. Open the Main Menu, and then click Setup (
Resolution.
2. Select the desired output resolution of the DVR (800x600, 1024x768, 1280x1024).
3. Click Video-Out Update and then click Yes at the prompt to save your changes.
Solution 3: Lower the resolution using the remote control
If you do not have access to a secondary monitor, try the following steps to manually change the
resolution using the remote control. The steps must be followed precisely.
To change your screen resolution to 800 x 600 using the remote:
1. Press the ESC button (
2. Press the Menu button(
3. Press the FWD button(
4. Press the Enter button (
5. Press the Down button (
6. Press the Enter button (
7. Press the Decrease button (
8. Press the Down button (
9. Press the Enter button (
10. Press the FWD button(

Copyright 2012 Lorex Technology Inc.
) >Video-Out Setup>Video-Out
) repeatedly to exit all menus.
).
).
).
) three times (4-channel) / four times (8/16-channel).
).
).
).
) and wait 5 seconds.
), and then press the Enter button (
Monitor/Display:
).
2