Replacing The Drive Motor - Invacare Leo Service Manual

SERVICE MANUAL
6.4

Replacing the drive motor

ATTENTION! Risk of accident.
When parking the scooter on the scooters support wheels it is no longer slowed by the
engine brake. The scooter can roll away out of control.
· Place the scooter rear frame on a supporting wooden block before you remove the wheels.
ATTENTION! Risk of accident.
Accidental rolling can lead to accidents.
· Secure the scooter against rolling away.
NOTE:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
NOTE:
The plugs on the electronic module cannot be wrongly connected because all plugs have a
different size and only fit in one socket.
Requirements:
· Open spanner, 10 mm.
· Open spanner, 17 mm.
· Oblique pliers
· Rubber hammer
· Phillips screwdriver
· Supporting wooden block
· Self-locking nut 17 mm
·
Secure the scooter against rolling away.
·
Place supporting wooden block under the
frames at battery holder height.
From the operating manual:
·
Remove the seat.
·
Remove batteries.
·
Remove the drive unit.
Further work:
·
Cut through cable ties (1) and remove.
·
Fold up electronics cover (2).
22
®
Invacare - Leo