Simrad AP25 Instruction Manual page 41

Simrad AP25 Autopilot
Press the STBY button to leave the User setup.
Set shallow water
40
Compass
Select the compass to be used if more than one
compass is connected.
Note! Compass can only be selected in STBY mode
Navigation
Select a source for NAV mode steering.
Position
Select the source for position data.
Wind Angle
Select the source for Wind Angle.
Wind Calculated
Select the source for Calculated Wind data for the
Simrad group. The autopilot uses internal source
irrespective of the selected source.
Water Speed
Select the source for water speed (normally the same
as the source providing Log data).
Water temperature
Select the source for water temperature (normally the
same as the source providing depth data).
DisLog
Select the Log source.
Depth
Select the source for depth data.
Depth source information
Use the course knob to set the shallow water alarm
limit.
Range: 0-100,0 m (0-328 ft.)
The setting of the alarm is local. In a multistation
system, however, the setting representing the
shallowest water limit will activate the alarm even if
this setting is on an "inactive" unit.
20222139A