R3000X Remote Control (Nfu); Js10 Joystick (Nfu); Automatic Steering - Simrad AP25 Instruction Manual

2.5

R3000X Remote Control (NFU)

SIMRAD
STBY-AUTO
Simrad R3000X
Notes !
1. When NAV or NoDrift mode is selected in User Setup
2. NAV or NoDrift modes can only be entered from the Control
2.6

JS10 Joystick (NFU)

The principle is similar to that of R3000X Remote Control (see
above). The rudder will move as long as the lever is offset to
Port or Starboard. JS10 has no mode change feature.
When a NFU steering lever or a remote control is operated, the
Note !
control units become "Inactive".
2.7

Automatic Steering

When AUTO mode is selected, the AP25 automatically picks the
current boat heading as the set course and maintains the
simultaneous rudder angle. This gives a bumpless transfer at the
mode change.
20222139A
Push button for
Port and Stbd
commands
STBY/automatic
Automatic
modes are active
when the lamp is
lit.
unit.
In STANDBY mode, the rudder will
move as long as the Port or Stbd button
is pressed.
In AUTO mode the set course will
change 1° each time the button is
pressed.
Note!
If you keep the button pressed, it will
automatically change the setting in
increments of 3° per second.
Mode changes are as per table below.
Initial mode 1
STBY AUTO
AUTO STBY
1
NAV/NoDrift STBY
)
Operation
st nd
press 2 press
STBY
AUTO
2)
AUTO
15