Table of Contents
Advertisement
Orienting SMART Board Software
Although SMART Board software assigns a default orientation, you may want to perform an
orientation to ensure the greatest possible level of accuracy as the computer accurately tracks
your contact with the screen. For more information, see the SMART Board software online Help.
NOTE: You can start the orientation by pressing and holding both pen tray buttons simultaneously.
Starting the System Components
Your system consists of the interactive whiteboard, the projector and the computer. Your
interactive whiteboard is always ready to use but you may have to start the other components.
To start up the projector
If you purchased a projector separately from your interactive whiteboard, start up the projector
following the manufacturer's instructions supplied with your projector.
If you received an NEC VT676 projector with your interactive whiteboard, start up the projector as
follows:
1. If you have not done so already, connect the projector's power cable to a power outlet and turn
on the projector's Main Power switch.
2. Press and hold the POWER ON button on the projector's remote control for a minimum of two
seconds.
To start up the computer
1. Turn on your computer.
2. When the computer desktop appears on the interactive whiteboard, touch the screen.
–
If the pointer appears and it tracks the movement of your finger, your interactive
whiteboard is ready to use.
–
If the pointer appears but it doesn't track the movement of your finger, you must configure
the COM port. For more information, see the SMART Board software online Help.
Shutting Down the System Components
Depending on your system preferences, you may choose to shut down your computer when the
interactive whiteboard isn't in use. Similarly, you may choose to put the projector into standby
mode or shut it down when it's not in use.
CAUTION
30
If your interactive whiteboard includes an NEC VT676 projector, please note that
this projector has been designed for use under normal operating conditions only.
Normal operating conditions are defined as product use that does not exceed eight
hours per day and 260 days per year. Exceeding these operating conditions could
cause projector damage. Damage caused by such extended use is not covered by
the product warranty.
Using the Interactive Whiteboard
99-00479-03 REV B0
Advertisement
Table of Contents
