SERVICE MANUAL
7
Test procedures
7.1
Testing the motor
Requirements:
● Phillips screwdriver size 2
● digital multimeter with resistance measurement
●
Remove the rear panel as described in Chapter 8.1.2.
●
Pull the motor plug (3) out of the electronic module.
●
Connect the digital multimeter to the motor plug contacts (3) and measure the resistance
between the contacts.
Note
A resistance of between 0.5 and 5 ohms indicates a motor ready for operation.
A resistance of between 15 ohms and infinity indicates a defective motor. High resistances are
normally caused by bad connections or worn carbon brushes.
32
®
Invacare
- TDX-SP / TDX-SP N