SERVICE MANUAL
8.12.2 Adjusting the wheel fork
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
● You should seek help from a second person.
Requirements:
● Phillips screwdriver size 2
● 5/8" socket spanner
Note
The front and rear wheels are adjusted in the same manner. The following illustrations only show
the front castor.
●
If necessary, remove the Philips screw (1) and the cover cap (2).
●
Get help of a second person to tilt the mobility aid to the rear.
●
Rotate the wheel forks (5) upwards.
●
Let go of the wheel forks so that they can swing downwards again.
●
Adjust the nut (4) with a 5/8" socket spanner so that the wheel forks are not too loose but can
still rotate freely.
The wheel forks should oscillate to the opposite side a maximum of once and then come to
rest facing downwards.
●
Place the mobility aid on all four wheels again.
●
Test the mobility aid's manoeuvrability.
●
Repeat the adjustment steps if necessary until the castors are correctly adjusted.
●
Replace the cap (2) and tighten the Philips screw (1) finger-tight.
104
®
Invacare
- TDX-SP / TDX-SP N