Toshiba Satellite M500 Maintenance Manual page 167

Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figures 4-11 to 4-14.
1. Place the keyboard face down on the top cover.
2. Connect the keyboard flexible cable to connector and the keyboard LED cable to
the connector on the main board.
3. Turn the keyboard face up and set it in place.
4. Secure the keyboard with following two screws.

M23L FLAT HEAD screw
5. Make sure that there is no gap between the keyboard and the edge of the top
cover.
6. Put the keyboard cover into its slot and press it.
7. Secure the keyboard and keyboard cover with three screws on the bottom case.
 M27L
 M23L
4-28
FLAT HEAD screw
FLAT HEAD screw
[CONFIDENTIAL] SatelliteM500/M500D Maintenance Manual
4 Replacement Procedures
2
1
2