BenQ PU9730 User Manual page 48

• Startup Logo
Press ◄► arrow key to enable /disable the startup logo function.
• Trigger
The projector features one trigger output. If the projector comes with an auto screen device,
you can connect it to the trigger to open the screen when the projector powers up. This
function may have a 2-3 second lag before powering up.
• Auto Search
Press ◄► arrow key to enable/disable the Auto Search.
• Dynamic Black
Press ◄► arrow key to enable/disable dynamic black mode.
• 3D
Set up 3D format and sync method. The projector displays options available for setup and dims
those unselectable by detecting connected input signal type. Please ensure you have connected
to input signal before 3D setup. DO NOT undertake 3D setup without connecting to an input
source.
DISPLAY
Direct Power On
3D Format: Point to this option and press Enter key to enable 3D playback and set up 3D
options.
Off: Disable 3D display mode. 3D mode is enabled once Auto, Side by Side, Top/Bottom or
Frame Sequential mode is selected. To disable 3D mode, select Off then press Enter.
Auto: Enable 3D format once Frame Packing, Side by Side, Top / Bottom, or Frame packing
input format is detected. This function applies to the following input signal only:
• HDMI 1.4a 3D input signal
• HDMI 1.4a 3D signal sent to the projector through digital transmitter
Side by Side: Set 3D format to Side by Side manually. This option applies to HDMI input
signal or HDMI signal through a digital transmitter.
Top / Bottom: Set 3D format to Side by Side manually. This option applies to HDMI, DVI, or
DisplayPort input signals or these signals through digital transmitter.
Frame Sequential: Set input format to Frame Sequential.
DLP Link: Select to disable or enable DLP Link sync.
3D Swap: Set 3D Swap to Inverse if left and right eye 3D image inversion by 3D glasses is
needed. If image looks normal, keeps current settings, Normal, intact.
3D 24Hz projection: Set frame rate to 144fps or 96fps when input signal is at 24Hz.
48